LG V-net PQNUD1S00 Bedienungs- Und Montageanleitung Seite 23

■ Using wireless remote controller
ON OFF
SET CANCEL
PLASMA
2. Address check mode
1) With the top right key pressed, press the Reset button.
(Press the left key for more than 3 seconds.)
2) Press the On/Off key once directing the remote controller to the indoor unit.
The indoor unit shows the setting address and the address setup is completed.
(The time and method of the address display can differ depending on the indoor unit type.)
3) Reset the remote controller and use it
❉ Depending on the manufactured date of the wired/ wireless remote controller, the above
function might not work.
Since this is a function not relevant for consumer in using the product, setup the remote
controller to enable address setup during installation.
❉ When setting the address, refer to the details on the previous page.
1. Address setting mode
1) With the top left key pressed, press the Reset button.
(Press the left key for more than 3 second)
2) Using the temperature adjustment key, set up the indoor unit
address
❉ Setup range: 00-7F
ex)
• No use For Power Distribution Indicator
Address • Used for Central Control settings
check
Address
3
setting
A
3) After setting the address, press the On/Off key once
directing the remote controller to the indoor unit.
4) When indoor unit shows the setting address, the address
setup is complete.
(The time and method of the address display can differ
depending on the indoor unit type.)
5) Reset the remote controller and use it.
How to set each Indoor Unit
Userʼs Manual 23