Possible Applications; Ordinary Maintenance - Sol Welding INOXA 250 HF Betriebsanleitung

Instruction Manual
Introduction
To obtain the best performance from the machine and ensure the
longest possible life of all its components you must careffully follow
the instructions for the use and maintenance detailed in this ma-
nual. In the interest of our customers we suggest any maintenance
or repair of the equipment has to be made by qualified personnel.
All our products are subject to a constant development.
We are therefore compelled to reserve the right to make any ne-
cessary or useful changes in design and equipment.

ORDINARY MAINTENANCE

Avoid any deposit of metallic dust inside the generator.
Disconnect the generator from the Main Line, before operating
any servicing!
Standard checks the generator:
• Operate an internal cleaning by using low pressure
compressed air and soft bristle brushes.
• Check the electrical connections and all the rest of
the connecting cables.
For the maintenance and the use of gas regulators consult the
specific handbook.
2 GB

1. POSSIBLE APPLICATIONS

The power sources type INOXA 250 HF, INOXA 360 HF, INOXA
250 HFP and INOXA 360 HFP are suited for cc ELECTRODE and
TIG Liftarc, TIG HF (*) in the 250 / 360A range.
• It is forbidden to use the equipment for different application
from the ones listed in this manual.
A different use from the one here by described can compro-
mise the security and the reliability of the equipment.
We suggest not to use the Inverter Power Sources INOXA
(standard version):
• In environments with high concentration of humidity and
dust.
• In connection to motorgenerators.
• With Input cables longer than 50 mt.
Contact the service centre for advice and precautions, in case the
unit must be installed and used under the above listed conditions.
It is suggested to make a maintenance cleaning of the unit
every 2-3 months of work, for this operation, please contact
the service centre.
(*) In the INOXA HFP series, it is possible to select the PULSED
TIG modality in order to guarantee an excellent cleaning of the
welding with a less thermal load.
More over, the possibility to memorize up to 10 JOB (working
benchmarks) gives the possibility to the operator, to memorize and
recall real working programs.
INOXA SERIES