System Default Setting - Blaupunkt SA 2900R Bedienungsanleitung

4. System Default Setting

4.1. Entry/Exit Time and Device Attribute
When the system is armed and an Entry device is triggered, the Entry timer will begin to count down (default 20 seconds). The system must be disarmed
before the timer expires, or a Burglar alarm will be activated.
When the system is being armed, the Exit timer will begin to count down (default 30 seconds), the system will ignore any sensors triggered during this
period. The user should use this duration to leave the premises before the system is armed.
NOTE: The Entry Timer only works with device set to "Entry". For device attribute detail and Entry/Exit Time programming, please see later chapter
"Programming Mode."
4.2. Alarm Activation
When an alarm is triggered, the system will report to programmed telephone numbers according to their priority. Depend on your setting, the system
will dial the telephone numbers you entered in the system and play voice message upon connection, or send an SMS message.
4.3. Address Message
The Address Message will be played in the beginning of all your voice message reports to notify the recipient your user information. Please make sure
to record your own Address Message by referring to "Programming Mode." Default Address Message is "Alarm System."
4.4. Alarm Length
Default alarm length for siren upon activation is set to 3 minutes. To change the alarm length, please refer to "Programming Mode."
4.5. Jamming and Interference Detection
The Control Panel is capable of detecting signal jamming and interference, the function is disabled by default, if jamming and interference is of concern
to you, please see chapter "Programming Mode"
8