Operation - Blaupunkt SA 2900R Bedienungsanleitung

7. Operation

This chapter covers system general characteristic under normal operation.
7.1. Away Arm
Away Arm will arm all devices in the system.
Arming the System
When the system is under Disarm mode:
"Arm"
1. Press the key on the Control Panel, Remote Controller, or Remote Keypad.
2. The Exit Timer will be displayed and begin to count down according to system setting.
3. When the Exit Time is up, the Control Panel will sound a long beep.
Stopping the Exit Timer
"Disarm"
1. Press the key on the Control Panel and enter a User PIN Code; press the
Disarm
press the key on Remote Keypad.
2. The Exit Timer will stop and the system returns to Disarm mode.
Extending the Exit TImer
"Arm"
1. Press the key on the Remote Controller and Remote Keypad again.
2. The Exit Timer will be reset and start counting from the beginning.
7.2. Home Arm
Home Arm will partially arm the system and allows free movement inside the house.
Arming the System in Home Mode
When the system is under Disarm mode:
"Home"
1. Press the key on the Control Panel, or Remote Controller, Remote Keypad.
2. The Exit Timer will be displayed and begin to count down according to system setting.
3. When the Exit Time is up, the Control Panel will sound three short beeps.
Mode.
Stopping the Exit Timer
The Exit Timer can be stopped in the same way as Away Arm mode..
Extending the Exit Timer
"Home"
1. Press the key on the Remote Controller and Remote Keypad again.
2. The Exit Timer will be reset and start counting from the beginning.
NOTE:
The Remote Keypad has the option to choose between "Arm without User PIN Code", or "Arm with User PIN Code". When the keypad is
set to "Arm with User PIN Code", you need to enter the PIN Code then press Armor Home key to arm the system.
7.3. Force Arm
When you arm the system, if any fault event exists, the Control Panel will sound a ding-dong warning sound to indicate arming is prohibited, the fault
event will be displayed on screen.
At this moment, you can first rectify all of the problems and then clear the Fault Display and you will be able to arm the system normally.
If you want to Arm/Home Arm the system with the fault situation persisting following the steps below to Forced Arm.
ARM / HOME
1. Press button on the Control Panel, you will be ask to confirm Force Arm action, press
For Remote Controller, Remote Keypad, press
Alarm On
will be displayed on the screen and the system enters Away Arm Mode.
Home
ARM / HOME
button again.
15
"Disarm"
key on Remote Controller; or enter a User PIN Code and
will be displayed on the screen and the system enters Home Arm
OK
to double confirm.