Blaupunkt SA 2900R Bedienungsanleitung Seite 14

6.4.15. Siren Tamper
This function is only used for optional external sirens. If the Control Panel has included external siren in the system, their tamper switches can be enabled
and disabled remotely.
 Siren Tamper On is set as factory default.
 When the Siren Tamper is turned off, it will automatically revert to On after about an hour if not switched back.
NOTE: For other devices, the tamper function will be disabled when the Control Panel is under
Programming Mode.
6.4.16. H. Temperature (Optional Temperature Sensor Required)
The Control Panel features High and Low Temperature report function which requires a Temperature Sensor to use.
The H. Temperature option is for you to set the High Temperature Threshold. When the temperature exceeds this threshold by 1°C, a SMS report will be
sent to programmed telephone number.
 You can set the temperature within the range of -10°C to +50°C
 When entering temperature value, press Up key to select negative value. Down key to select positive value.
 When the temperature drops to 3°C below the threshold, a SMS report will be sent to programmed telephone number to notify the recipient of
High Temperature Restoration.
 You can set a High Temperature Threshold and choose to enable or disable the reporting function. If reporting is disabled, the system will not send
out report when the temperature exceeds the threshold, but a log event will still be recorded in system

High Temperature Warning is Disabled by factory default
6.4.17. L. Temperature (Optional Temperature Sensor Required)
The system will send Low Temperature SMS reports when temperature drops to 1°C below the Low Temperature Threshold.

When the temperature returns to 3°C above the threshold, a SMS report will be sent to programmed telephone number to notify the recipient of
Low Temperature Restoration.
 Low Temperature setting format is the same as High Temperature setting.
 Low Temperature Threshold must be at least 4°C lower than High Temperature Threshold.
 Low Temperature Warning is Disabled by factory default.
6.4.18. SIM Unlock
If the SIM Card's PIN Code is not disabled, you can use this function to enter SIM Card PIN Code and unlock the SIM Card.

Enter the SIM Card PIN Code and press OK key to unlock SIM Card.
6.5. Device +/-
6.5.1. Add Devices
1. To learn in a device, select Add Device, press "OK" to confirm.
2. Press the test /learn button on the device, refer to device manual for detail.
3. If a signal is detected, the screen will display the device information, press "OK" to confirm.
If the device already exists in system, the screen will display "Already exist in system":
4. Select the Zone number for the device, press "OK" to confirm.
5. For Door Contact, PIR sensor, and EIR sensor, you need to select one of the three attributes for the device, available attributes include:
 Burglar (B)
When the device is triggered under Away Arm or Home Arm mode, a Burglar Alarm will be activated immediately.
When the device is triggered during Entry or Exit countdown, the alarm will not be activated.

Home Omit (O)
When the device is triggered under Away Arm mode, a Burglar Alarm will be activated immediately.
When the device is triggered under Home Arm mode, the alarm will not be activated.
13