Before You Begin; Getting Started - DERMAPEN 4 Handbuch

3 - INSTALLATION & SETUP INSTRUCTIONS
3.1 – Before You Begin
Before commencing treatment, it is important to carefully read and acknowledge all
Safety Warnings and Operating Instructions presented in this manual. Refer to 10 – Safety
Warnings.
3.2 – Getting Started
To get started with the Dermapen 4™, fi rst register your clinic and the Dermapen 4™ with the
DermapenWorld™ Companion App. The App must be fi rst downloaded to a compatible
smartphone or device.
3.3 - Powering on the Dermapen 4™
1. Press and hold the Primary Button until the Dermapen 4™ emits an audible tone. This
should take around 3 seconds. The Status LED lights blue and the Speed Indication Ring
will begin to fl ash.
2. Once the Dermapen 4™ is powered on, the Speed Indication Ring and Depth Indication
Digits will be displayed. The Status LED will light blue to indicate device is ready for
normal operation.
3. Adjust the Speed Indication Ring and Depth Indicator Digits as required.
4. Press the Primary Button once to activate Treatment Mode.
3.4 – Status LED and Audible Tones
The Status LED displays three di erent states:
• Blue: Normal Operation
• Orange: Attention
The Dermapen 4™ emits the following audible tones:
Single Tone: Indicates a button press
Double Tone: Indicates Speed/Depth setting accepted, or there is an alert requiring attention
Triple Tone: Indicates a Critical Battery Alert or Motor Error (refer to 9 – Troubleshooting)
9