Operation - Collomix AqiX Originalbetriebsanleitung

Assembly/commissioning
The AQiX water dosing system is set to the unit of "litres"
ex works.
The device is delivered with a standard ½" hose connec-
tion. This can be unscrewed and replaced with a different
tap connection, such as with a bayonet coupling.
Standard hose couplings with 1/2" or 3/4" hose connection
can be used as a quick-release or bayonet coupling.
Connect the water hose to the meter. The water hose may
not be pressurised.
Only connect the hose to the hose coupling. No hose may
be connected to the water outlet (7).
IMPORTANT: venting
After every connection made to the water hose, first make
sure that the air can escape from the device.
• Press the "START/PAUSE" (12) button to switch on the
device.
• Set the display to "0" with the "0.00 - Man." (10) button.
• Keep holding the "START/PAUSE" (12) button until the
water flows out without any interruption.

Operation

Switching on the device:
The AQiX water dosing system is switched on using the
"START/PAUSE" (12) button. The unit first appears in the
display and then the last set quantity.
Setting the metering quantity
Adjust the metering quantity using both keys (11) "+"
and "-". The water quantity can be set in increments of
0.1 litres. Keep the button depressed to advance quickly.
Start dosing:
Press the "START/PAUSE" (12) button to start the metering.
You can interrupt the metering process. Press the "START/
PAUSE" button to do this. Pressing the button again starts
the metering process where it was interrupted.
Storing a metering quantity
Frequently used metering quantities can be saved by press-
ing the "M1" / "M2" (8+9) buttons. Set the desired quantity
value with the "+" and "-" button. Then hold "M1" / "M2"
for 2 seconds until the value in the display flashes. Press
"M1" / "M2" to call up the stored value. It will appear in
the display
Manual metering:
Press the "Man/0.00" button (10). Then press "START/
PAUSE" (12). The water will run for as long as you hold
down the button. The dispensed quantity of water is
shown in the display.
Converting the unit of measure:
The water dosing system can be used with three different
units of measure: Litres, quarts and US gallons.
To switch between them, hold the "Man/0.00" button for
5 seconds until 0_ _ appears in the display. Set the desired
number for the respective unit of measure using "+" and
"-". Confirm each digit with the "START/PAUSE" button. Fi-
nally press Play twice. The device switches off and changes
the mode.
Value 100 = litres | 200 = quarts | 300 = gallons
You can hold the device in your hand for metering or hang
it on the mixing bucket or on the mixing bucket of a mixer.
The device is hung between the water outlet (7) and the
retaining bracket (6)
Hanging on a bucket