Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Charging The Battery - Taurus ULTIMATE GO Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
ENGLISH
Appliance Type
Ultimate Go
Ultimate Digital
DESCRIPTION
A
Accesories:
A-1 Lance and multiuse brush
A-3 Extralong lance
B
Extension tube
C
Motorized turbobrush
E
Filter
F
Battery indicator
G
ON/OFF button
H
Body
I
Dust tank
J
Lithium batteries
K
Wall bracket
L
Power supply
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Do not use the appliance without its filter(s)
correctly in place.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance to gather up water or
any other liquid.
- Do not use the appliance if the on/off switch
does not work.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any circum-
stances whatsoever.
- The battery/ies should be stored at a tempera-
ture of below 40ºC.
- Only use the appliance for carrying out dry
tasks.
- Do not use the appliance on any part of the
body of a person or animal.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.

INSTALLATION

- Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET:
- The appliance has a wall bracket (K) which
must be fixed to the wall.
- Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive...
- Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
- Fit the appliance into the wall support.

CHARGING THE BATTERY

- Caution: A new battery is not fully charged and
must therefore be charged before the appli-
ance is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (L) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 4 to 5 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is rec-
ommended that the first charge of the battery
be of 6 hours in duration).
- Insert the battery into the charger.
- Connect the charger (L) to the jack using the
socket on the appliance. The socket is located
at the lower/back part of the appliance.
- The pilot light will come on to indicate that the
charger is charging the battery.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ultimate digital

Inhaltsverzeichnis