Specifications; Wireless Sensor - Emos E3078 Bedienungsanleitung

GB WIRELESS THERMOMETER + 3× SENSOR (433 MHz)
The thermometer displays radio controlled clock, data on indoor and outdoor temperature, calendar,
and date.
It features a memory of minimum and maximum readings, alarm clock with the snooze function.
Read carefully this manual before using the product.

Specifications

Radio controlled clock
Indoor/outdoor temperature: 0 °C to +50 °C; -20 °C to +60 °C
temperature increments: 0.1 °C
temperature measurement accuracy: ±1 °C (0 °C to 40 °C), ±2 °C (-20 °C to 0 °C, 40 °C to 60 °C)
Wireless sensor: transmission frequency 433 MHz
Radio signal range: up to 30 m in an open area
maximum number of sensors: 3
Power supply:
Main station: 2× 1.5 V AAA batteries
Sensor: 2× 1.5 V AAA batteries
Dimensions and weight:
Main station: 173 × 55 × 25 mm; 129 g (without batteries)
Sensor: 84 × 64 × 25 mm; 53 g (without batteries)
Overview of buttons
Main station
Press button
UP 1 step forward
DOWN 1 step back
MODE displays alarm time
SNZ/ activates alarm snooze/display backlight
LIGHT
MAX/MIN displays max./min. readings
°C/°F changes temperature units °C/°F
RESET resets all set values
Battery installation and putting into operation
When first starting, insert the batteries (2× 1.5 V AAA) into the thermometer, then into the sensor
(2× 1.5 V AAA).
If using multiple sensors, set a different channel number for each sensor by the switch (1, 2, 3) located
under the battery cover before inserting batteries.
Make sure to insert the batteries with the correct polarity.
Improper insertion will damage the thermometer or sensor, which is not covered by the warranty!
Only use alkaline batteries of the same type, do not use rechargeable batteries.
If no signal from the sensor is detected, remove the batteries from the sensor and the thermometer
and repeat the procedure.
Low batteries in the thermometer or the sensor are indicated by a low intensity of display backlight
and the icon.

Wireless sensor

We recommend placing the sensor on the north side of the house.
The sensor is resistant to dripping water, however, it should not be exposed to rain permanently.
The range of the sensor may decrease substantially in urban areas.
Hold button
deletes outdoor temperature readings
-
setting the time
-
-
-
2