Using The Microscope - Woodley Vision V4002 Bedienungsanleitung

4.0 USInG THe MICROSCOPe

4.1 Adjust the observation head
loosen the lock-screw, turn the observation head to a comfortable position for observation, and then
lock the lock-screw.
4.2 Place the specimen on the stage
lock the specimen slide on the mechanical stage using the slide clamp. Ensure that the specimen is
centred over the stage opening by adjusting the coaxial knobs of the stage.
4.3 Lamp settings
The microscope is fitted with power white lED illuminator. Before turning on the light, read the section
6.3 about electrical safety precautions. Insert the plug of the power supply into the jack on the rear.
Turn the brightness adjustment knob in order to switch the light on and to a brightness suitable for
observation.
4.4 Adjust interpupillary distance
hold the right and left parts of the observation head by both hands and adjust the interpupillary dis-
tance by turning the two parts until one circle of light can be seen.
4.5 Focus and diopter adjustment
rotate the coarse focusing knob to bring the slide into focus using an objective with a low magnifica-
tion. Adjust the fine focusing knob to get the image sharp and clear while observing with your right
eye, then turn the dioptric adjustment ring on the left eyepiece until a sharp and clear image can be
observed also with the other eye. Turn the tension-adjust-knob to get a suitable tension for the focus
system. When the image is in focus, turn the nosepiece to choose the objective you need.
4.6 Condenser adjustment
hold the lever of the condenser and rotate it up or down until you reach a clear and uniform sample
illumination.
4.7 Set the numerical aperture
Adjust the aperture of the iris diaphragm to set the numerical aperture of the illuminator, thus control-
ling image contrast and resolution.
4.8 Solar panel
If a solar panel is needed to work with microscope, please refer to the instructions enclosed with solar
panel kit. use the DC jack from back of microscope to plug the solar panel.
4.9 Fitting the mirror
If the microscope is supplied with a plano-concave mirror, this can be used with the microscope in-
stead of the electrical light, please follow these instructions:
1) Make sure the equipment is not plugged into the electrical power.
2) unscrew the light house from the illuminator, (black part).
3) screw the mirror in place of the light house.
Page 7