Inhaltsverzeichnis
Werbung
Installation
Constructing Arrays: Module to Module Connections
1)
Use RoomMatch™ Array Suspension Angle Calculator software to determine the hole positions on the array frames for required
aiming angles and confirm array does not exceed load limits of frame. (You may also contact your local Bose Technical Support or
Field Engineer for this information.)
2)
Place array frame directly under the chain motors positioned for intended array location.
3)
Attach 5/8 –inch forged steel shackles to array frame in hole positions determined by aiming software.
4)
Lower chain motors and attach to shackles installed on array frame.
5)
Raise array frame to height slightly greater than that of the 1st module (upper most) to be installed.
6)
With 1 person per side, place the 1st module directly under the suspended array frame. See Figure 5.
7)
Lower the array frame onto the 1st module, guiding the pins of the temporary handles into the slots of the frame.
8)
Using handles, pull the module forward to align the bolt holes of the module and frame. (Note: it may be helpful to use an alignment
punch tool in the rear holes and then thread the bolts in the front holes first.)
9)
Insert 4 bolts (2 per side) and finger tighten each until all bolts are installed.
10) Tighten all 4 bolts with socket tool using torque of 35 to 40 foot-pounds (47 to 54 Newton-meters).
11) Raise array frame to height such that bottom surface of module is approximately waist height.
12) Position 2nd module directly under array.
13) With 1 person per side, lift the 2nd module and guide the temporary handle pins into the alignment slots of the 1st (top) module
side plates. See Figure 6.
14) Holding the handles of the 1st (top) module stationary, pull forward on the handles of the 2nd (bottom) module to align the bolt
holes of both modules.
15) Insert 4 bolts (2 per side) and finger tighten each until all bolts are installed.
16) Tighten all 4 bolts with socket tool using torque of 35 to 40 foot-pounds (47 to 54 Newton-meters).
17) Remove temporary installation handles from top module. Handles in module just installed should remain for now.
18) Repeat steps 11 – 16 for to install additional modules in the array. Do not exceed load limits of frame.
19) Remove any remaining temporary installation handles before elevating array to final height.
20) Connect field wiring, test loudspeaker operation, and then elevate array assembly to final operating position.
Figure 5. Positioning Frame on 1st Module
For additional details on array configuration and installation, refer to the document RoomMatch™ Array Design and Installation Manual
which is available for download at pro.Bose.com.
Page 12
Installation and Safety Guidelines
Figure 6. Attaching 2nd Module to 1st
pro.Bose.com
English
Werbung
Inhaltsverzeichnis
