Setting Parameters - Gewiss SYSTEM Serie Handbuch

The SET/PROG key is pressed once to set the parameters.
The message SET is displayed on the VDU.
At this point the following can be modified, in sequence:
- the day of the week
- the hour
- the minutes
The value of each parameter is confirmed by pressing the MODE key.
The setting phase is exited by pressing the SET key again or, in automatic mode, 30 sec-
onds after the last key entry.

Setting parameters

Setting the day of the week
When the day of the week bar blinks, select the day of the
week using the
Sunday=7).
The value set is confirmed by pressing the MODE key
within 30 seconds.
Setting the hour
When the hour figures blink, set the hour using the
keys.
The values set are confirmed by pressing the MODE key
within 30 seconds.
Setting the minutes
When the minutes figures blink, set the minutes using
the keys.
The values set are confirmed by pressing the MODE key
within 30 seconds.
23
keys (Monday=1, Tuesday=2.....
E
N
G
L
I
S
H