Cleaning & Maintenance - Lacor 200 Serie Gebrauchs- Und Instandhaltungsanleitung

CLEANING / MAINTENANCE
1.- Pull the plug out of the outlet and make sure that the blender is disconnected before you
start cleaning it.
2.- Wash the blender only by hand and NEVER in a dishwasher. The head with the motor must
NEVER be submerged in water or liquid
3.- If the blade area is still dirty after hand washing, put the end of the blender in a bath of hot
water, no deeper than the MAX line, and run it at full speed for 2 minutes.
NOTE:
To clean the blender, use only non-aggressive detergents or dish washing
products.
4.- The blade is extremely sharp so you should exercise extreme caution to avoid cutting your
fingers or hands. Make sure to put all the parts back in their correct place after cleaning.
5.- The motor may stop running by itself after prolonged use due to overheating.
Wait a few minutes and the fuse will automatically reset itself when the motor has cooled
down.
6.- Before storing the blender for extended periods put some olive oil on the surface of the
blades.
7.- Make sure to store the blender in a dry, well ventilated place without excess humidity.
49