Cleaning & Maintenance - Lacor 61681 Gebrauchs- Und Instandhaltungsanleitung

Wall support
The wall support allows you to hang the blender chopper with the assembled blender shaft + a
blender shaft or wire whisk.
NOTE: Before making the holes for mounting it, ensure that their position and placement are
correct and suitable
CLEANING / MAINTENANCE
MAINTENANCE:
1.- Ensure the cooler is unplugged before cleaning or if the cooler is not in use.
2.- Wash the blender shaft by hand, never in the dishwasher. The motor head must never be
submerged in water or liquid.
3.- In order to clean the device, use non-aggressive detergents or dish cleaning products.
Never use harsh detergents or solvents.
4.- Keep appliance away from any heat source or direct sunlight.
5.- The blender is an electrical appliance. To avoid injury or death from electrical shock do not
operate the wine cooler with wet hands, while standing on a wet surface or while standing in
water.
6.- Do not use outdoors or in wet conditions.
CLEANING:
1.- Once the blender has been used, switch off the engine and disconnect the plug, dismantle
the pieces to wash them in water, dry them, and assemble them again.
2.- The blades may be disassembled, and therefore you should be extremely careful in order to
avoid cutting your hands and fingers. After cleaning, be sure to place all the parts in their
correct position.
3.- The main body cannot be washed in water. Clean it only with a damp cloth.
4.- Make sure that the appliance is stored in a dry, well-ventilated place, free from dampness.
34