Operation - Lacor 200 Serie Gebrauchs- Und Instandhaltungsanleitung

220 SERIES
1.- Insert the crushing blade (5) into the coupling (4) in the blender body (3).
The connectors of both parts must match up.
2.- Then, screw the blade (5) in counter-clockwise until it's fully secured.
3.- Plug the blender into a 220-240V/50-60Hz outlet.
4.- Push the power button (2) and the blender will start running.
5.- If you're using a model with variable speed, turn the speed control (1) and change the speed
to between 4.000 and 20.000 r.p.m.
6.- If you're using a model without variable speed, the speed doesn't change and by default it will
spin at a constant speed of 20.000 r.p.m.
7.- To keep the blender running continuously the power button must be pressed at all times.
8.- To turn off the blender, just release the power button (2) and the motor will stop running.
9.- Unplug the blender after each use.
NOTE:
If you want to use the whisk attachment, the procedure is exactly the same as
described in this section.
350/500 SERIES
1.- Insert the crushing blade (8) into the coupling (6) in the blender body (5). The connectors of
both parts must match up. Use the white arrows on the coupling (6) to align the parts.

OPERATION

47