Safety Advice - welltherm PB0210 Bedienungsanleitung

GB

1. Safety advice

1. The infrared heating panels are designed for use with an AC voltage 230 Volt, 50 Hz.
2. If you intend to install more than one heating element please contact an electrically
skilled person!
3. The heater must not be covered (for example by textiles or similar)!
ATTENTION: Danger of overheating and fire hazard!
4. The infrared heating panels are equipped with a temperature limiter which will switch
the panel off at higher temperatures. It will switch on again when the panel is cooled
down.
5. Infrared heating panels must not be positioned directly under a wall outlet.
6. Infrared heating panels will not withstand higher humidity rates.
7. It has to be secure that the electrical circuit of the panel heater can be de-energized by
switch, fuse or thermostat at any time.
8. The minimum distance to other objects should be 400mm on the front and 200mm on
the sides.
9. For mounting the infrared panel heaters to brick walls or stone walls use the delivered
assembly materials. For mounting the infrared panel heaters to different fixation basics
please use suitable special towels and screws which fulfill the demands on load capacity.
For ceiling mount please use towels and screws that are suitable for fire protection
requirements!
10. The infrared panel heater must be remounted, cleaned and transported in cold
condition only.
11. The panel heating element must not be used by persons (including children) with
limited physical or mental capabilities without a supervisor. Children will never realize the
danger on electrical devices! For this reason don't let your children without supervision
with the panel heater.
Please position the panel heater in a way that it will be out of the reach of children.
12. The infrared panel heater must not be opened, modified or repaired by the user.
Repairs can only be executed by the specialized staff of company GmbH.
13. The front of the heater consists on powder coated metal.
10