Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
!"#*%')#(@#'(&*%
%
1. Safety advice
1.
Welltherm infrared heating panels are designed for use with an AC voltage
2. If you intend to install more than one heating element please contact an electrically skilled
person!
3. The heater must not be covered (for example by textiles or similar)!
ATTENTION: Danger of overheating and fire hazard!
4.
Welltherm infrared heating panels are equipped with a temperature limiter which will switch the
panel off at higher temperatures. It will switch on again when the panel is cooled down.
5.
Welltherm infrared heating panels must not be positioned directly under a wall outlet.
6. Welltherm infrared heating panels will not withstand higher humidity rates.
7. It has to be secure that the electrical circuit of the panel heater can be de-energized by switch,
fuse or thermostate at any time.
8. The minimum distance to other objects should be 400mm on the front and 200mm on the sides.
9. For mounting the Welltherm infrared panel heaters to brick walls or stone walls use the
delivered assembly materials. For mounting the infrared panel heaters to different fixation basics
please use suitable special towels and screws which fulfill the demands on load capacity.
For ceiling mount please use towels and screws that are suitable for fire protection requirements!
10. The Welltherm infrared panel heater must be remounted, cleaned and transported in cold
condition only.
11. The panel heating element must not be used by persons (including children) with limited
physical or mental capabilities without a supervisor. Children will never realize the danger on
electrical devices! For this reason don't let your children without supervision with the panel heater.
Please position the panel heater in a way that it will be out of the reach of children.
12. The Welltherm infrared panel heater must not be opened, modified or repaired by the user.
Repairs can only be executed by the specialized staff of company Welltherm GmbH.
13. The front of the heater consists on powder coated metal.
Due to the material properties with increasing temperatures the heater front swells. This is normal
and will not affect the function! Therefore it is no reason for complaint.
GB
%
+,-.,/%012+03452613789#%"#$%:%;8//<=8>?%
230 Volt, 50 Hz.
&(%
Werbung
Inhaltsverzeichnis
