AB myPilot Gebrauchsanweisung Seite 24

The following sound sources can be listened to:
Microphones (Front and Rear, Headpiece, T-Mic 2)
•
FM receivers
•
T-Coil
•
Wireless streamed sources from the ComPilot
•
To conduct a listening check of the auditory input sources of the Naída CI, the recipient must
first connect the Naída CI Listening Check to the Naída CI.
Remove the battery from the Naída CI, if
not already removed. Connect the top of the
Naída CI Listening Check to the Naída CI
Connect headphones to the 3.5 mm
auxiliary plug on the side of the
Naída CI Listening Check.
When the Naída CI Listening Check is attached, the Naída CI immediately enters listening
check mode, and the AB myPilot automatically goes to the Listening Check menu. From the
menu, you can select the desired input source you would like to listen to.
If you select T-Coil, make sure you are synced to either a loop or Phonak myLink. Provide input
to the FM transmitter to assess audio quality.
1
3
2
Connect the bottom of the Naída CI
Listening Check to the battery (any of
the Naída CI power sources will work).
AB myPilot User Guide
23