Vapor 3000 Gebrauchsanweisung Seite 28

PREPARING THE APPLIANCE
READY FOR USE
-Fill the tank (G) with drinking water (Fig. 4).
-Fill the tank (H) with non-foamy detergent (Fig. 5).
Do not use any acids or toxic detergents. They are
harmful to your health and may damage the
appliance.
- Connect the detergent tank (H) and water tank (G) to
the appliance following the colour combination (Fig. 6).
- Plug the appliance into the wall socket (Fig. 7)
Then carry out the following procedure:
a) Press the two buttons (A and B) at the same time.
The red warning light (F) will blink for about 1 minute at
short intervals while water is being loaded into the machine.
b) After approximately 1 minute, the electronic protection
device will activate itself to interrupt the water loading
process and the red warning light (F) will remain on.
Deactivate switch (A). Wait approximately 30 seconds
and press switch (A) again. To complete the water loading
process, it may be necessary to repeat the operation a
couple of times. When the red warning light (F) stops
blinking, boiler filling will be completed and the electronic
unit will activate the heating resistances.
CAUTION
Fig. 4
Fig. 5
Fig. 6
Fig. 7
24
G
BLUE
RED
BLACK detergent
water
water return
16 Amp.
H