How Do I Load Sheets Of Paper? (General Guidance) - HP Designjet 110plus Serie Kurzübersicht

HP Designjet 110plus/110 plus nr printer—

How do I load sheets of paper? (general guidance)

There are three ways of loading sheets of paper into the printer:
extensions
to support
paper
• The input tray at the front of the printer for multiple sheets of paper between
76 × 142 mm (3 × 5.6 inches) and 457 × 610 mm (18 × 24 inches) (C+).
You can load up to 50 sheets of paper of 0.2 mm thickness (or 150 g/m²) in
the unextended tray, or 25 sheets of the same thickness in the extended tray.
Envelopes can also be loaded in the input tray.
• The front path for single sheets of paper between 110 × 205 mm
(4.3 × 8.1 inches) and 625 × 1625 mm (24.6 × 63.9 inches) (A1 oversize).
• The rear path (upper slot) for single sheets of thick paper or other media
between 110 × 205 mm (4.3 × 8.1 inches) and 625 × 1625 mm
(24.6 × 63.9 inches) (A1 oversize). The rear path (lower slot) is used for roll
input.
• The automatic roll feed enables you to load roll paper into the rear path. When
roll paper is loaded into the printer, it obstructs the paper path; therefore roll
paper must always be unloaded before printing on sheet paper (see page 8).
However the paper is loaded, it should always be loaded in portrait mode: the
leading edge of the paper should be the shorter edge.
The output tray extensions may be used to support sheets of paper up to 19 inches
in length. For sheets longer than 19 inches, close the output tray extensions and use
the extended input tray to support the paper as it emerges from the printer.
output tray
front path
input tray
2
Quick Reference Guide
rear
path