Genius G60 Benutzerinformation Seite 9

ENGLISH
7.3. OPERATOR
After installing the sliding guide, install the operator:
1) Remove the plastic housing.
2) Unscrew the courtesy light.
3) Insert the gear motor shaft in the coupling located in the
sliding guide rear connection (fig. 20).
4) Fix the operator to the guide (fig. 21).
7.4. AUTOMATIC SYSTEM RELEASE
1) Establish the height of the release knob and cut off the excess
cord.
2) Tie a knot in the end of the cord and assemble the release
handle (fig. 22).
3) Pull the release lever downwards and make sure the door
can be moved manually (fig. 23).
4) Pull the release handle sideways in the direction of the door
(fig. 24). Check that, on releasing the handle, the LOCK
window located under the carriage is red. Manually move
the door until locating the carriage coupling point.
7.5. OUTSIDE RELEASE
If the automatic system is equipped with an outside release
device, conclude the installation already started (see par. 6.3.):
1) Cut the cable sheathing to size (fig. 25 ref. A).
2) Insert the cable in the sheath and through the special eyelet
of the connection bracket on the door (fig. 25 ref. B).
3) Cut the cable to size and assemble it with the inside lever of
the release handle (fig. 25 ref. C).
Fig. 20
A
B
C
Fig. 21
18
ENGLISH
Fig. 22
Fig. 23
LOCK
Fig. 24
Fig. 25