Speaker- & Rca Connections 2-Channel-Mode / 2 Mono Subwoofers Bridged - Hifonics Titan Series Bedienungsanleitung

Speaker & RCA Connections
3-Channel-Mode 2 Mono Subwoofer bridged
RCA & Speaker wiring:
• Connect the LINE INPUT of the amplifier to the head unit line output with appropriate good quality RCA cables.
• Connect the speakers/subwoofer with appropriate wires to the terminal block (SPEAKER OUTPUT/ - CH1/2 - Mono bridged +
and the subwoofer with CH3/4 - Mono bridged +) of the amplifier.
• The minimum final subwoofer impedance must not be lower than 4 Ohms per channelpair. Too low speaker loads result in too
high heat dissipation and may cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal
Do not connect speaker (-) to the ground or vehicle's chassis.
Subwoofer 2
4 - 8 Ohm
GND REM BATT+ 12V
POWER INPUT
Subwoofer 1
4 - 8 Ohm
X-Over-Switch (CH1/2 Subwoofer 1 & CH3/4 Subwoofer 2)
• Switch to the LP/BP-position (LOW PASS/BAND PASS), that the higher frequencies are cut off. The cut-off frequency can be
selcted by the LOW PASS-controller. In LP/BP-Mode the HI PASS-controller is working also as Subsonic-Filter. The Subsonic
frequency can be selected by the HI PASS-controller.
Input Level (CH1/2 Subwoofer 1 & CH3/4 Subwoofer 2)
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80 - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
Bass EQ (CH1/2 Subwoofer 1 & CH3/4 Subwoofer 2)
• This Controller regulates the Bass Boost from 0 - 18 dB.
Caution! Please use the Bass-EQ carefully. The additional boost may result in clipping or overload.
Bass Remote (CH3/4 Subwoofer 2)
• The provided Bass Remote regulates the Bass Level of CH3/4 from f.i. the driver's seat.
SPEAKER OUTPUT
+ MONO BRIDGED –
+ CH3 – + CH4 –
FUSE
+ CH1 – + CH2 –
Connect RCA outputs (CH1/2 or
CH3/4) of the head unit with LINE
INPUT (CH1/2) of the amplifier.
Caution!
Bass Remote Control -
Connection for remote
control. This Contoller
regulates the Bass Level
from f.i. the driver's seat.
15 18