Maintenance And Care; Warranty - Felisatti DI 22/1200GE2 Bedienungsanleitung

Drilling into metal, a
h,D
Impact drilling into concrete, a
h,ID
Uncertainty K
Use ear protection!
WARNING! The vibration level given in these
instructions has been measured in accordance with
a standardized measurement procedure specified in
EN60745 and can be used to compare devices. Different
uses of the device give rise to different vibration levels and
in many cases they may exceed the values given in these
instructions. It is easy to underestimate the vibration load
if the electrical power tool is used regularly in particular
circumstances.
Note. If you wish to make an accurate assessment of
the vibration loads experienced during a particular period of
working , you should also take into account the intervening
periods of time when the device is switched off or is running
but is not actually in use. This can result in a much lower
vibration load over the whole of the period of working.
ACCESSORIES
Accessories and their corresponding order number can be
found in our catalogues.

MAINTENANCE AND CARE

WARNING-Always unplug the machine before carrying out
work on it.
- When you notice a decrease in hammer output, take
the machine to an Official Service Centre.
- Tool inspection: Using a blunt cutting tool leads to
less efficient work and could damage the motor, there fore
cutting tools should be sharpened or replaced as soon as
any wear is noticed. Daily: Clean the tool holder.
- Inspect the mounting screws: Regularly inspect all the
mounting screws and ensure they are firmly tight-ened.
Should any screw be loose, tighten it immediately. Failure
to do so could put you at serious risk.
- Motor maintenance: Take the utmost care to ensure
that the motor winding is not damaged and does not
become damp with oil or water.
- Brush replacement: The brushes disconnect auto-
matically and should be replaced after 150-200 hours
use or when they are less than 10 mm long. Have them
replaced by an Official Service Centre.
- Clean the machine thoroughly after each use with a
blast of dry air.
- The vents of the machine should be kept clear at all
times.
- Check that the mains lead is in good condition. If it is
not, take it to an Official Service Centre to have it replaced.
- Use only Felisatti accessories and spares. The parts
the changing of which is not covered in this instruction
manual, should be replaced in a Felisatti Official Service
Centre (See Warranty/Official Service Centre ad-dress
leaflet).

WARRANTY

See general warranty conditions printed on the attached
sheet
3.352 m/s²
--
1.5 m/s²
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.
DISPOSAL
Do not dispose of electric tools in
the household waste!
7