Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION AND SAFETY
OPERATION
Clean the surface in contact with the meat with damp cloth before operating. Use only damp cloth to clean the
machine.
1.
Mount the worm to the head so the stud faces outside. Mount the cutting blade on quadrangular bulge
of the worm`s stud with cutting surface toward the outside. Mount the mincer plate chosen in
accordance with your own preference for blade and tighten the lock nut.
2.
Turn the switch after connecting the machine.
3.
Check the worm`s direction of rotation. (For three-phased models)
4.
If the worm rotates in the opposite direction, turn the switch in opposite direction.
5.
Do not allow meat to cover the worm while processing.
6.
Pay attention to veins and nerves before mincing. To produce meat containing veins and nerves, special
blade must be used; otherwise the machine may be damaged.
7.
In case the worm is squeezed, run the worm in the opposite direction within 2-3 seconds. To perform
this operation, turn the switch in the opposite direction.
8.
Do not operate the machine when empty.
the machine in the opposite direction within 2 seconds. After operating the machine
It is very important to operate the machine in hygiene environment in sense of human
SHUTTING DOWN
•
Make sure no meat or mince left in the machine first.
•
Shut down the machine by turning the main switch to "0" position.
OPERATIONAL CAPACITY
The capacity of the appliance depends on factors listed below:
Structure of the meat
Environmental variety
Ambient temperature
Meat type and quality
7054.0050 / 7054.0055
7054.0060 / 7054.0065
(with head cooling)
Tightening the lock nut too loose may mash the meat,
tightening too much may break plate or blade.
Feed the meat after starting the machine. İn case the meat is mashed operate
in the opposite direction the lock nut may loosen. Tighten the lock nut slightly
Check the plate and the knife periodically. Sharpen if necessary.
and environmental health. Therefore do not operate the machine in moist,
Model
7054.0045
www.combisteel.com
before reoperation.
Capacity / Hour
125 kg / Hour
400 kg / Hour
400 kg / Hour
7
Werbung
Inhaltsverzeichnis
Fehlerbehebung
