LG DV908IH2S Bedienungsanleitung Seite 73

Operation
Symptoms
Appliance will not
turn on.
Appliance does not
heat.
Water leaks.
Appliance runs and
pauses by itself after
the drying cycle
finishes.
Performance
Symptoms
Clothes take too long
to dry.
Power cord is not properly plugged in.
• Make sure that the plug is securely plugged into a grounded outlet
matching the appliance's rating plate.
House fuse is blown, circuit breaker has tripped, or power outage has
occurred.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
House fuse is blown, circuit breaker has tripped, or power outage has
occurred.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
The water container hose or the drain hose is not connected correctly.
• Connect the water container hose or the drain hose correctly.
The door is closed while laundry or foreign substance is caught in the
door.
• Check if laundry or foreign substance is caught in the door before using
the appliance. If water leaks continuously, contact the LG Electronics
Customer Information Centre.
This is how the anti crease option works.
• Make sure that the anti crease option has been set. The option is
designed to prevent creases that are formed when the laundry is not
unloaded promptly after the drying cycle. When the option is set, the
appliance runs for 10 seconds and pauses for 5 minutes. The option is
works for up to 2 hours.
House fuse is blown, circuit breaker has tripped, or power outage has
occurred.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
Appliance is overloaded.
• Divide extra large loads into smaller loads for better drying performance
and efficiency.
Appliance is underloaded.
• If you are drying a very small load, add a few extra items to ensure proper
tumbling action. If the load is very small and you are using Sensor Dry
programmes, the electronic control cannot properly sense the dryness of
the load and may shut off too soon. Use Timed Drying programmes or add
some extra wet clothes to the load.
Possible Cause & Solution
Possible Cause & Solution
EN
33