Installing The Drain Hose - LG DV908IH2S Bedienungsanleitung

2
Remove the two screws from the bottom of the
rear cover on each side as illustrated below.
3
Align the stacking kit holes and the rear cover
holes.
• 3-1) 600 mm
• 3-2) 550 mm
4
Fasten the two screws that were removed
earlier from the dryer to the stacking kit.
5
Use the four screws in the accessory box (16
mm) to assemble the washing machine rear
cover and stacking kit.
6
The procedure for the opposite side will be the
same.

Installing the Drain Hose

Normally, condensed water is pumped up to the
water container where water is collected until
manually emptied. Water can also be drained out
directly to a mains drain, especially when the dryer
is stacked on top of a washing machine. With a
connecting kit for the mains drain hose, simply
change the water path and re-route to the drainage
facility as below:
1
Separate the anti-backflow lid(a) and the
water container hose(b) from the connecting
kit.
2
Attach the anti-backflow lid(a) to the head of
the connecting kit and then connect the drain
hose(c) to the opposite side of the connecting
kit.
CAUTION
• If the hose is installed in a way that leaves it
bent or pinched, drainage may not function
properly.
NOTE
• It is possible to install the drain hose even if
the appliance is not stacked on the washing
machine.
EN
b
a
a
c
15