R
6
10
9
photo 1
APPLIANCE OPERATION
Before the first use wash the bowl (10), dough hooks (7), beaters (6) and blender.
photo 2
OPERATION
- before the operation make sure that all the components were assembled properly
- plug in the appliance
- the mixer starts its operation after a proper speed is selected with the switch (2).
By changing its position five different speeds can be obtained.
"TURBO" button (3) is used to achieve immediately the maximum speed corresponding to the position "5" of the
switch (2)
When the appliance is no longer used:
- set the switch (2) in the position "0" and unplug the appliance
- tilt the arm of the stand (5) and remove the dough hooks or beaters by pressing the button (1)
- remove the bowl (10)
1
4
5
GENERAL DESCRIPTION
1. Dough hooks and beaters release button
7
2. Switch and speed control (5 settings)
3. TURBO button - high speed
4. Body of the mixer
5. Arm of the stand
6. Beaters
7. Dough hooks
8. Blender
8
9. Stand
10. Bowl
11. Lockout system of the
mixer body
12. Housing
13. Tilt button for the arm
of the stand
ASSEMBLY
- position the appliance on a flat, hard and stable surface
- make sure the appliance is unplugged, and the switch (2) is set in the position "0"
- assembly the body (4) on the stand arm (5)
For this purpose remove the housing (12) and insert the body on the catch in the arm of
the stand (5) and then lock the body by turning the lockout feature (11) clockwise.
- press the button (13) and tilt the arm of the stand (5)
- place the bowl (10) with products on the stand (9)
- place the dough hooks (7) or beaters (6) in proper sockets on the bottom part of the
mixer. Attachments need to be assembled in pairs - two dough hooks (7) or two beaters
(6)
Assemble the attachments in the order shown in the photo 2. Insert the flanged ending
into the socket marked on the housing of the body (4) with the symbol
- press the button (13) and lower the arm of the stand (5)
INSTRUCTIONS FOR USE
3
2
5
MIXER R101
11
TECHNICAL DATA
- power: 200W
- supply voltage: 230V ~ 50Hz
- maximum time of continuous
operation: 5 minutes
- interval time before reuse:
10 minutes
12
13