Product Familiarisation; Intended Use; Unpacking Your Tool; Before Use - GMC GMCP30C Anleitung

Storage
• Clean the tool completely after use
• Be careful not to damage the fuel tank, or fuel lines, when it is placed on the ground
• Ensure that the tool will not be subject to impact damage; any damage could cause the
tool to become unsafe
• Store the tool away from direct sunlight
• Ensure that fuel and oil is stored in a safe place, away from heat, direct sunlight or any
source of ignition
• Whenever the machine is likely to be out of use for an extended period of time, proceed
as follows:
• Empty the fuel tank completely
• Protect all metal engine parts from corrosion by coating them with oil
• Remove the spark plug, put a few drops of oil into the cylinder and then pull the recoil
starter 2 to 3 times in order to distribute the oil evenly
• Replace the spark plug
• Never store the machine where children may gain access to it
THIS PRODUCT PRODUCES POISONOUS EXHAUST FUMES AS SOON AS THE ENGINE
IS RUNNING. THESE GASES MAY BE COLOURLESS AND ODOURLESS. TO REDUCE
THE RISK OF SERIOUS OR FATAL INJURY, NEVER RUN THE MACHINE INDOORS, OR
IN POORLY VENTILATED AREAS. ENSURE PROPER VENTILATION WHEN WORKING
IN TRENCHES OR OTHER CONFINED SPACES.
Blower Safety
Never use for vacuuming heavy, dense, sharp, or lammable materials such as metal,
• stones, branches, ir cones, glass, barbecue coals, cigarette ends, dust or gravel
• Never use for vacuuming liquids
Never operate close to an open ire
•
• Always keep the air inlets clear of debris and check the inlets immediately if the tool is
getting hot
Never insert your hands or ingers into any openings while the tool is running or
•
connected to a live mains supply
• The noise levels generated in use may be a nuisance to neighbours. Consider neighbours
when operating

Product Familiarisation

1. Spark Plug Combi Tool
2. Fuel Mixing Bottle
3. Wheels
4. Blower Nozzle
5. Vacuum Nozzle
6. Lower Blower Tube
7. Upper Blower Tube
8. Mode Selector
9. Blade Housing
10. Front Handle
11. Debris Collector Flange
12. Shoulder Strap
13.Debris Collector
14. Ignition Switch
15. Throttle Trigger
16. Rear Handle
17. Air Filter Cover
18. Air Box
19. Idle Adjustment Screw
20. Choke Lever
21. Primer Bulb
22. Fuel Tank
23. Fuel Cap
24. Exhaust Mufler
25. Spark Plug Access Cover
26. Recoil Starter

Intended Use

Petrol-powered blower vacuum suitable for blowing and vacuuming lightweight, dry garden
waste such as leaves, grass cuttings, clippings and litter. Suitable for domestic use only.

Unpacking Your Tool

• Carefully unpack and inspect your new tool. Familiarise yourself with all its features and
functions
• Ensure that all parts of the tool are present and in good condition. If any parts are missing
or damaged, have such parts replaced before attempting to use this tool

Before Use

WARNING: Ensure the spark plug lead is disconnected before attaching or changing any
accessories, or making any adjustments, to prevent accidental starting.
Blower tube assembly
1. Carefully place the Blade Housing (9) on a secure, lat surface with the blade opening
facing upwards
2. Remove the ixing screws from the Upper Blower Tube (7) using the Phillips head
screwdriver feature of the Spark Plug Combi Tool (1) (Image A), and place the screws in a
secure location.
9
GB