Specifications - Virutex ASM582T Gebrauchsanweisung

Before connecting the vacuum cleaner to
the mains ensure that the voltage is the
same as that on the vacuum cleaner.
Before connecting the power tool to the
vacuum cleaner, ensure the voltage of
the vacuum cleaner is the same as that
for the tool.

1. SPECIFICATIONS

Power..............................................................................1,400 W
Airflow...............................................................215 m
Water lift.............................................................2400 mm H
Tank capacity..................................................................21l
Connected power through socket.................2000 W max
Weight..................................................................................12 kg
2. DESCRIPTION
1 – Polyester filter to be placed in the tank during dust
collection.
2 – Class "M" cartridge filter.
3 – Suction inlet. (Suction nozzle).
4 – Flexible hose.
5 – Power tool socket.
6 – Switch.
7 – Clamps to fix the engine block to the tank.
3. PLANNED USE
The ASM582T vacuum cleaner can be used for all types
of dust, shavings and non-hazardous dirt. Its class "M"
classification indicates that it is suitable for collecting
mineral and wood dust with MAK values of >0.1 mg/m
The use of the vacuum cleaner also creates a healthier
working environment.
To achieve maximum vacuum cleaner
efficiency, filters should be cleaned
after each use.
4. OPTIONAL ACCESSORIES
8245847-Dust collector kit ASC482U-ASM582T
8299645 Paper filter bag for ASM582T
8299656-Connection Y for ASM582T
6446073- 3.5 m standard suction connection.
USE OF PAPER FILTER BAG
Only use the dust collection bag with the filter car-
tridge fitted.
The bag ensures the recovery of the vacuumed dust in
hygienic conditions.
Vacuuming of sharp or damp materials may damage
the dust collection bag.
Change the bag when the material collected reaches
two-thirds of total capacity.
The bag cannot be reused and must always be replaced.
5. PREPARING AND TURNING ON THE VACUUM
CLEANER
5.1 ELECTRICAL CONNECTION
The service voltage shown on the charac-
/h
3
teristics plate of the vacuum cleaner must
O
be the same as the power supply voltage.
2
Before plugging the machine into the
mains, ensure that the switch is in the
(central position "0" of switch F) (Fig. 4).
5.2 ON/OFF SWITCH
This machine has a switch with three positions: "AUTO",
"0" and "MANUAL" F (Fig. 4).
In position "0", the vacuum cleaner is off.
"MANUAL" position
The vacuum cleaner turns on immediately. There is also
power to the machine's socket box.
"AUTO" position
On selecting the "AUTO" position, the machine automa-
tically shakes to clean the filter and the machine's socket
E (Fig. 4) provides power. The vacuum cleaner switches
on when the tool connected to this socket is turned
. on. When the tool is turned off, the vacuum cleaner
3
continues to run for 10 seconds to clear the dust from
the tubes and it automatically shakes to clean the filter.
Do not exceed the maximum working power shown on
the machine's socket box: 2,000 W.
Before turning the switch to "AUTO", en-
sure that the connected tool is turned off.
6. AUTOMATIC FILTER CLEANING FUNCTION
The vacuum cleaner comes with an electromagnetic
device that automatically shakes the filter to remove
accumulated dust. The slight noise it makes when doing
this does not indicate that there is a problem with the
vacuum cleaner.
7. HOW TO USE THE VACUUM CLEANER
- Place filter A (Fig 3) inside the tank (suction nozzle).
5