Important Information - ZEN’AROME LILI Bedienungsanleitung

The reaction time required for the device
insufficient
No mist, but red
Limestone, essential oils or other deposits on the
LED lights flash. ceramic disk and/or the nebulizer.
Water temperature is too cold or too high.
Water is not clean.
The nebulizer
demineralized water used.
Splashes Incorrect position of the cover.
Water is leaking Rubber joint not well installed.
The water level in the vase is too high.
No water in the vase or water level insufficient.
Mist insufficient,
The temperature of the unit is too low or too
low diffusion.
high.
Water is not clean or has been stagnating for too
long in the vase.
Limestone, essential oils or other deposits on the
ceramic disk, water sensor level and/or the
nebulizer.
The temperature water is too cold or too high.
Unusual odor The water is stagnant for too long in the vase.
1. Add water before adding a few drops of essential oil or perfume extract in water.
2. Do not operate the unit without water. Check the water level before use.
3. Use demineralized water and alcohol-free essential oils or perfume extract for diffusion.
4. Clean the nebulizer, water sensor level and the ceramic disc as shown in this manual
regularly.
5. Place the unit out of reach of children.
6. Do not move the unit when full of water and / or when it is running.
7. Place the unit on a flat, stable surface, away from the edge.
8. To avoid all accidents, ensure that the cable is safely secured.
9. This product must only be powered by the supplied AC adapter. Please respect the
operating voltage indicated on the transformer.
10. Use in an environment between 10°C & 30°C, water temperature between 5°C & 20°C.
11. Change the water in the vase regularly. Empty the vase when not in use.
12. Only for indoor use.
13. Do not place any device or equipment sensitive to water spray within 30cm from this
diffuser when it's working.
14. For your own safety avoid close contact with the ceramic disk when the diffuser is on,
this can cause minor injuries.
15. If one of the components of this product is damaged, the device must not be used.
16. Once purchased we accept no liability for damage to property, injury or damage to plants
or animals due to improper use or non-compliance with safety regulations.
17. If the instructions are not adhered to as stated in the manual, it will cause the
cancellation of the guarantee.
does not properly detect

IMPORTANT INFORMATION

Once connected, please wait 4-6 seconds before
the device operates normally.
Clean the ceramic disk, the water sensor and the
nebulizer according to the indication on this manual
Water temperature must be between (5-20°C).
Clean the vase and fill it with clean water.
Add some tap water till the diffuser operates
normally.
Place covers in the middle of the vase on the
nebulizer, (cf. INSTALLATION).
Check that the Rubber joint is well sealed.
Remove some water from the vase. (Check the ideal
water level in INSTRUCTION).
Add water until the water level sensor is fully
emerged.
Place the unit in a room at room temperature for
half an hour before use.
Clean the vase and fill it with clean water.
Clean the ceramic disk, water sensor level and
nebulizer according to the cleaning instruction.
Water temperature must be between (5-20°C).
Clean the vase and fill it with clean water.
EN
11