Technical Data; Battery Exchange - Ace instruments AFM-5 Bedienungsanleitung

waste. Used batteries may contain harmful substances that can
cause environmental or health damage. Please return all depleted
batteries to electrical appliance stores, who collect them for free.

Battery exchange:

To replace the battery, push the battery cover on the rear of the
unit up and replace the discharged battery with a new one. Be
aware of the polarity when inserting the battery (+/- pole). Put the
battery compartment cover on the rear panel and press it gently
on the device until it clicks. In the EU the return of used batteries
is mandatory by law. All depleted batteries and also rechargeable
batteries will be recycled. This way valuable resources like iron,
zinc and nickel can be retrieved and are reusable then. Battery
recycling is the easiest lesson in environmental protection – so
please support it!
The shown garbage bins mean that batteries or rechargeable
batteries must not be thrown into the household waste. The signs
below the garbage bins are acronyms for the chemical substan-
ces inside the battery:
Calibration:
To maintain the accuracy of the ACE AFM-5 Breathalyzer, you
can send the device for a calibration service to ACE Instruments
(see www.ace-instruments.net). The calibration is not mandatory,
but the accuracy of ACE AFM-5 Breathalyzer will decrease stea-
We recommend sending it as a parcel, so that
dily without it.
in cases of loss an inquiry or proof of delivery is possible.
to changes in the product, the procedures stated can change.
This can take place without prior notice or adaptation of the
operating manual and is no cause for complaint, return or price
reduction. The user is responsible for recognizing discrepancies
between the operating manual and the actual handling of the
ACE Instruments AFM-5 Breathalyzer and must react accordingly.
Hg: Battery
g
contains Mercury
Cd: Battery
g
contains Cadmium
Pb: Battery
g
contains Lead
Due

Technical data*:

Sensor: Fuel Cell sensor
Accuracy: +/- 0.05‰ (per mill) with reference to
1.0‰ at 25°C (per mill = measurement
unit in the EU) OR +/- 0.005% BAC (with
reference to 0.1% BAC at 25°C
(% BAC = measurement unit in the USA
OR +/- 0.025mg/L with reference to
0.5mg/L at 25°C (mg/L = measurement
unit in UK)
Detection Range: 0,000 - 4,000‰ OR 0,000 - 0,400%
BAC OR 0.000 - 2.000 mg/L (per mill =
measurement unit in the EU), in the App
"Alcofind" you can change the
measurement unit into % BAC (USA)
or mg/L (UK)
Warm-up Time: Within 15 seconds at 0.5‰, it may vary
depending on the value of per mill / BAC
which was measured
Connectivity: Bluetooth 4.0 LE
Dimension: 68mm x 41.5mm x 16.9mm (L x W x D)
Weight: 43g (battery included)
Power Supply: 1 piece of 1.5V AAA size Alkaline battery
Working Temperature: 5°C - 40°C
Storage Temperature: 0°C - 40°C
Calibration: Every 12 months or after 500 tests
*The technical data are subject to change without prior
notice for functional improvements.