Safety Instructions - Klarstein Steam Buddy Bedienungsanleitung

EN
14

SAFETY INSTRUCTIONS

Before using for the first time, please check if the voltage rating on the type plate
corresponds to the mains voltage in your home, if not, please contact with the seller.
• Use an earthed wall socket; the cord and plug must be dry.
• Unfold the AC cord completely before using.
• Make sure to unplug the appliance from the socket when leaving the iron even for a
short while, and stand the iron on its end. Please leave the iron away from the touch
of children. Take care of the iron when it is on.
• The iron will be of high temperature when used, never touch it with hand or close to
the flammable product in order to avoid the accident.
• Caution: Unplug the appliance from the socket before filling the iron with water or
pouring out the remaining water.
• Never immerse the iron in water or other liquid.
• Please send the iron to our special repair agent for repair if any damage on cord.
• Deposit or Mineral in the water will lead to generate the scales and block the steam
hole, therefore it is advisable to use distilled water.
• In order to prevent overriding the circuit load, please don't use other appliances
with high power at the same line.
• If necessary to connect with several appliances with high power at the same line,
please use the cord with 10A, otherwise the cord with less than 10A will be too
heat. The cord should be placed carefully in order not to be pulled out or stumbled.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
• The iron must not be left unattended while it is connected to the supply mains.
• The iron must be used and rested on a stable surface.
• When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
• The iron is not to be used if it has been dropped, if there are visible signs of damage
or if it is leaking.