Terdens 2017 Handbuch Seite 11

Display Icons for transmitter
Transmit signal
Low battery
Temperature
SETTING UP:
6. First, insert the batteries into the Temperature Station (see "How to install and
replace batteries in the Temperature Station" below). Once the batteries are in
place, all segments of the LCD will light up briefly and a short signal tone will sound.
Then the indoor temperature, Time: 0：00：00 with 24hrs; Date: 1/1, 2004, Thu. Then
at channel 1, the weather is slightly cloudy, the moon is semi-circle. It will detect the
temperature, humidity, automatically. Then the second is flashing, means the product
is working after that entering RF receiving mode for 3 minutes. If the indoor tempera-
ture is not displayed after a few seconds, remove the batteries and wait for at least 10
seconds before reinserting them. Once the indoor data is displayed proceed to step 2.
7. Within 3 minutes of activating the Temperature Station, place the batteries into the
Temperature Transmitter (see "How to install and replace batteries in the Tem-
perature Transmitter" below).
8. After inserting the batteries into the transmitter, the Temperature Station will start
receiving transmissions from the transmitter. The outdoor temperature should then be
displayed on the Temperature Station. If this does not happen within 15 minutes, the
batteries will need to be removed from both units and reset from step 1.
9. The Temperature Station can take up to 3 remote transmitters. If you have pur-
chased additional transmitters, follow step 2 for all extra transmitters. However, en-
sure that you leave 10 seconds in between the reception of the last transmitter and
the set-up of the following transmitter. The Temperature Station will number the
transmitters in the order of set-up, i.e. the first transmitter will have the temperature
displayed with the number 1 against it and so on.
10. When all the transmitters are set up, there is a testing period, during which the
display switches quickly between all the received transmitters at random, according to
which random transmission it receives. Pressing any key will stop this process and the
display will show the temperature for the first transmitter. The process also stops au-
tomatically if no keys are pressed for a few minutes.
11. In order to ensure sufficient 433 MHz transmission however, this should under good
conditions be no more than 30 meters from where the Temperature Station will be
finally positioned (see notes on "Positioning" and "433 MHz Reception check").
RF Channel selection
Humidity