Herunterladen Inhalt Inhalt Diese Seite drucken

Periods Of Non-Operation; What To Do If - AEG SANTO K 4 12 40-6i Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für SANTO K 4 12 40-6i:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5. Switch on the appliance.
6. Set the temperature regulator to obtain the maximum coldness and run the appliance
for two or three hours using this setting.
7. Reload the previously removed food into the compartment.
WARNING!
Never use sharp metal tools to scrape off frost from the evaporator as you could damage
it. Do not use a mechanical device or any artificial means to speed up the thawing process
other than those recommended by the manufacturer. A temperature rise of the frozen food
packs, during defrosting, may shorten their safe storage life.

Periods of non-operation

When the appliance is not in use for long periods, take the following precautions:
• disconnect the appliance from electricity supply
• remove all food
• defrost
6)
• leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food
inside from spoiling in case of a power failure.

What to do if...

WARNING!
Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or competent person must do the troubleshooting that is not
in this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor operates
continually.
6) If foreseen.
and clean the appliance and all accessories
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
Possible cause
What to do if...
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Refer to "Replacing the lamp".
Set a higher temperature.
Do not keep the door open longer
than necessary.
29

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis