Troubleshooting - Simer OD6601G Bedienungs- Und Wartungsanleitung

GB
ELECTRICAL SPECIFICATIONS
Motor
Series HP
OD6601 1/6
2533 1/6
PERFORMANCE
LPM (GPM) AT TOTAL METERS (Feet)
0m
Series (0')
OD6601 70
2533 (18.5)

TROUBLESHOOTING

Fault Probable Cause
Pump won't start Pump is not plugged in
or run
Blown fuse
Low Line Voltage
Defective motor
Pump won't shut off Restricted discharge
(obstacle or ice
in piping)
Restricted intake
Pump operates but Low line voltage
delivers little or
no water.
Worn or defective parts
or plugged impeller
Restricted intake
Individual
Branch Circuit
Watts Req. in Amps
400
400
1.5m 3m 4.6m
(5') (10') (15')
55 40 21
(14.5) (10.5) (5.5)
Remedy
Check to make sure that the pump is
plugged into the correct outlet
Replace with fuse of correct size
Check wire size from main switch on
property. If it is OK, contact power
company
Replace the pump
Remove the pump and clean the
pump and piping
Remove the pump and clean
the intake
Check wire size from main switch on
property. If it is OK, contact power
company
Replace the pump
Clean out the intake screen
15
15
6.1m
(20')
4
(1)
4