Simer OD6601G Bedienungs- Und Wartungsanleitung Seite 3

GB
Ch. 4 - Installation
DANGER: Risk of electrical shock.
When installing, pump must be
unplugged. See electrical hazard instructions
on Page 2.
1. Set the pump on clean brick, cinder
block, or concrete in at least 51mm (2")
of water.
2. Connect the discharge line with the fit-
tings provided.
3. When using rigid pipe for the discharge,
a short length of rubber hose (fastened
with clamps) between the pump and the
discharge pipe will reduce noise and
vibration.
4. To avoid damage to the pump if the dis-
charge line freezes, make sure that any
part of the discharge line which might
freeze will drain to the outfall by gravity.
Ch. 5 - Operation
DANGER: Risk of electrical shock.
Do not handle the pump with wet
hands or while standing on a wet or damp
surface or in water. See electrical hazard
instructions on Page 2.
DANGER: Risk of electrical shock.
Before attempting to check why a
pump has stopped operating, disconnect the
electrical power to the unit. See General
Information, Nos. 1A to 1F, on Page 2.
1. The shaft seal is water cooled and lubri-
cated. To avoid seal damage, never run
the pump dry.
2. This pump will not remove all water. On
a flat surface, it will pump down to with-
in 3.1 mm (1/8") of the pumping surface.
WARNING: When the pump is running
continuously, keep it submerged to pre-
vent overheating.
3. This pump has an anti-airlock hole
(see Figure 1). Keep it clean for proper
operation.
.3
Figure 1
3
®
Anti-Airlock
Hole