AEG A92500HLW0 Benutzerhandbuch Seite 24

24 www.aeg.com
8.1 What to do if...
Problem
The appliance does not op-
erate.
The appliance is noisy.
Audible or visual alarm is on. The cabinet has been re-
Power indicator light is flash-
ing.
The lid doesn't close com-
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not suppor-
ted properly.
cently switched on or the
temperature in the appli-
ance is too high.
An error has occurred in
measuring the temperature
or the appliance is not work-
ing properly.
Food packages are blocking
the lid.
There is excessive frost.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is defective.
Temperature is set incorrect-
ly.
Large quantities of food to
be frozen were put in at the
same time.
The room temperature is too
high.
Food placed in the appli-
ance was too warm.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect to a different elec-
trical mains socket. Contact
a qualified electrician.
Check if the appliance
stands stable.
Refer to "High Temperature
Alarm" and if the problem
still occurs contact the near-
est Authorized Service Cen-
tre.
Contact the nearest Author-
ized Service Centre.
Arrange the packages in the
right way, see the sticker in
the appliance.
Eliminate excess frost.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the
lamp".
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.