Completing Installation - Gewiss GW 10 798 Handbuch

To cancel the combinations memorised on the various RF channels, turn the rotating
switch to position 9: the front LED will flash for 10 seconds (yellow) and then remain ON
(yellow) to indicate that all the channel combinations have been cancelled.
To interrupt the cancellation procedure, turn the selector switch to another position before
the LED stops flashing.
WARNING: it is not possible to perform selective cancellations: the
cancellation operation requires new learning of all the required RF
transmitters.
Insert the device in a Chorus support, making sure the EIB channel test
front button is to the left.
Complete the installation with other Chorus devices or hole covers and fix it to the relative
container (flush-mounted box, wall-mounted box etc).
Apply the finish plate.
INSTALLATION
Cancelling learnt RF channels

Completing installation

31
E
N
G
L
I
S
H