Electrical Connections - Gewiss GW 10 798 Handbuch

Figure B shows the electrical connections diagram.
1. Connect the bus cable's red wire to the terminal's red connector (+) and the black wire
to the black connector (-). Up to 4 bus lines (wires of the same colour in the same
connector) can be connected to the terminal (figure E).
2. Insulate the screen, the electrical continuity conductor and the remaining white and
yellow wires of the bus cable (should a bus cable with 4 conductors be used), which
are not needed (figure D).
3. Insert the bus connector into the special feet of the device. The fastener guides
determine the direction it should be inserted. Insulate the bus terminal using the
relative cover, which must be screwed onto the device. The cover guarantees that
the power cables and the bus cables are separated by at least 4 mm (figure F).
To memorise the combinations between the RF transmitter devices and the receiver,
please proceed as follows:
1. Turn the rear rotating switch on the receiver to position 1 : the front LED will come ON
(red) to indicate that the receiver is ready to receive a learning RF message to be
memorised.
2. Follow the instructions for the device that must be combined to generate the required
command message.
The LED will go OFF to indicated that the RF message has been learnt.
3. After 5 seconds the LED will come back ON and it is possible to memorise another RF
message, repeating the procedure 2 above. If the LED flashes (red), this means that
the memory is full (4 transmitters memorised on each channel) and it is therefore
necessary to use another channel.
4. If necessary, turn the rotating switch to the next position (2, 3 ... 8) and repeat
procedure 2 to memorise the other transmitters.
WARNING: do not turn the rotating switch to position 9.
5. After memorising all the required transmitters, turn the rotating switch to position 0
for standard functions In this position the receiver LED flashes green briefly each time
it receives a message from any of the learnt RF devices.
INSTALLATION

Electrical connections

RF channel learning process
30