PRESIDIUM SAM Benutzerhandbuch Seite 12

Turning on your SAM
Remove the protective cover from the tester. For first time
use, please remove the plastic cap from the probe tip.
(Fig.1.4).
Fig. 1.4
Press the Power button located at the lower end of the
device. (Fig. 1.5). Wait for approximately 10 seconds to
warm up to the predetermined tip temperature.
SAM
Fig. 1.5
While in the warming up period, a Blue light will blink
continuously. The light will stop blinking when it is "READY"
to be used (Fig. 1.6).
SAM
Fig. 1.6
The tester will shut down automatically after 10 minutes
of inactivity on battery mode.
9