Function Messages; Error Messages - Neumann Mission Programmieranleitung/Regelungsanweisungen

Function messages

Error messages

Cutting grass according to the program setting.
When it senses rain, Mission
you have programmed it to do so. When dry, Mission
and countdown and then return to mow. If you want Mission
turn it off then on again, but only when the rain sensor is dry or you can set the delay time
to 0 min.
Needs to recharge—during the journey to the base, the cutting blade is stopped in order to
save energy.
Charge is in progress—charge percentage are displayed.
Stand-by, will start according to program set.
According to the setting of "Customize work area", Mission
mow.
Mission has completed its charging.
®
1. If Mission is actually outside its territory: turn power off, take the Mission
®
territory. Turn power on.
2. If the Mission is inside its territory, check the LED on the charging base is green. If
®
not, check the charging base is connected properly to the charger and the charger is
connected to a suitable power supply. If so, it means that the boundary wire ends are
clamped incorrectly, and you need to reverse them.
3. If the LED light flashes green, check the boundary wire is well connected to the clamps to
the charging base. If the problem persists, check that the boundary wire hasn't been cut.
Refer to the "Programming" section to re-set your PIN.
1. Turn power off.
2. Turn Mission upside down and check if there's anything preventing the blade disc to rotate.
®
3. Remove any possible obstruction.
4. Turn Mission upright and take it to an area with short grass or adjust the cutting height.
®
5. Turn power on.
1. Turn power off: take Mission
2. Turn power on.
3. If the error message is still displayed; turn power off; turn Mission
there's anything preventing the wheels from rotating.
4. Remove any possible obstruction, turn Mission
will return to the Charging Base and stay there for the time
®
will automatically begin the delay
®
in an area free from obstacles.
®
upright, turn power on.
®
to mow before this, simply
®
is searching a certain area to
®
inside its
®
upside-down and check if
®
5
EN