Ingersoll-Rand 9001 Technische Produktdaten Seite 4

EN
Adjustments
Accessory Installation
Always turn off the air supply and disconnect the air supply hose before installing,
removing or adjusting any accessory on this tool or before performing any maintenance
on this tool.
1. The Upper Sleeve should be replaced each time a bit is replaced.
2. Replace the Lower Sleeve at the first indication of wear. Wear is indicated by a "rounding out"
of the square opening in the Lower Sleeve.
3. Replace the Rubber Bumper when the Lower Sleeve extends out of the Retainer Nut more
than 1/8".
For Threaded Retainer No. 9001-200
1. It is extremely important that the Retainer Nut is properly positioned on the tool. Under
normal circumstances, the Lock Spring is sufficient to keep the Retainer Nut in place.
2. When the tool is used in a continuous duty cycle, it is often necessary to use a Lock Key and
Lock Pin in conjunction with the Lock Spring. This will prevent the loosening of the Retainer
Nut which could cause damage to the bit and other front end components.
For Plain-Type Retainer No. 11001-18
1. To remove the accessory, clamp the Barrel in leather-covered or copper-covered vise jaws
with the accessory end up.
2. Remove the Lock Spring.
3. Slide the Retainer off the Barrel and remove the Rubber Bumper from the inside of the
Retainer.
4. Slide the Lower Sleeve off the accessory and remove the accessory from the Barrel.
5. To install the accessory, reverse the above procedure.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
WARNING
03530094_ed14