Communication Port; Connect The Loads - Atlantis Onepower S series Handbuch

1.5 Communication Port

Download the SW from
your PC (Windows 7/8/10). Connect the supplied interface cable to the USB computer
interface port on the back of the UPS. Connect to the computer. See software
document for installation instruction.

1.6 Connect the loads

First, plug the loads into the output connectors on the rear of the UPS then connect
the UPS with the AC Mains. To use the UPS as a master "On/Off" switch, make sure
that all of the loads are switch "On".
www.atlantis-land.com
Do not connect a laser printer to the outlets. These UPS
outlets provide battery power and surge protection to the
equipment when utility voltage is outside acceptable
limits.
23
(in the product page) and install it on
ENG