How To Access The Internet (Bridge Mode) - Kingston MobileLite Wireless G3 MLWG3 Bedienungsanleitung

4. Next to 'Enable Security', swipe the slider to the right and enter the preferred password. Please
make sure to type the password in correctly. Using the 'Show Password Icon' will help by
showing you the password as you type. A factory reset of the MLW device will be required if the
password was not entered correctly. Click Save.
5. The MLWG3 will restart and disconnect you from its wireless signal. Once restarted, reconnect to
the MLWG3 and enter the new password.
4

How to Access the Internet (Bridge Mode)

Traditionally, the Wi-Fi antenna on your mobile device is used to access the Internet. The MobileLite
Wireless, however, uses the Wi-Fi antenna on your Apple device to stream content, which effectively
disconnects your mobile device from the Internet. Fortunately, MobileLite Wireless's Wi-Fi antenna
supports bi-directional traffic and can be used for implementing a feature called Bridge Mode. This mode
allows you to be connected to the MLWG3 while it is connected to a Wi-Fi network (as a host client) that
has access to the Internet.
To set up this feature and see a list of available wireless networks in your range, follow the steps below:
1. Using the MLWG3 app, click 'Settings' at the bottom of the screen.
2. Click 'MLW Setup'.
3. Click 'Wireless Network Setup'.
1
Document No. iOS-MLWG3-011816.A00
2
MobileLite Wireless G3
5
3
Page 23 of 28