Description Of Symbols; Specification; General Safety - Silverline 456976 Gebrauchsanweisung

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice

Specification

Length: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .600mm
Range:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .90° from horizontal
Resolution:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.1°
Accuracy of digital inclinometer: . . . . . . . . . . . . . . . . . . + - 0.2°
Accuracy of vial:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0mm/m
Temperature range: . . . . . . . . . . . . . . . . . . . . . . . . . .0°C – 40°C
As part of our ongoing product development, specifications of
Silverline products may alter without notice
4
Original Instructions

General Safety

Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this tool, do not attempt to use it.
Trained, competent persons
• This tool should be used by trained, competent persons only
Children and pets
• Keep children and pets at a safe distance from the work area. Lock tools
away where children cannot gain access
Use the correct tool
• Do not force or attempt to use a tool for a purpose for which it was not
designed. This tool is not intended for industrial use
Keep your balance
• Do not overreach. Keep proper footing at all times and do not use tools
when standing on an unstable surface
Accessories
• The use of any attachment or accessory, other than those mentioned in
this manual, could be dangerous and result in damage or injury, and may
invalidate your warranty
Never stand on your tool
• Standing on your tool or its stand could cause serious injury if the tool
is tipped or collapses. Do not store materials above or close to the tool
in such a way that a person might stand on the tool to reach the stored
items
Check for damaged or missing parts
• Before each use, check if any part of the tool is damaged or missing.
Carefully check that it will operate properly and perform its intended
function. Check alignment of moving parts for binding. Any guard or other
part that is damaged should be immediately repaired or replaced by an
authorised service centre. DO NOT USE IF DEFECTIVE