Electrical Connection For Appliances With No Cable - Diamond D150/EK Handbuch

GB
2.2
•
The installation
manufacturer's
personnel.
•
Only a fixed connection is suitable for this equipment.
•
Position the machine and level it perfectly using the feet.
•
The flooring must be suitable for the overall weight of the machine.
•
Follow the indications on the installation drawing and set-up the
electrical, water and drain systems in the wash area.

ELECTRICAL CONNECTION FOR APPLIANCES WITH NO CABLE

a) Before connecting the equipment make sure that the electrical
system voltage and frequency match those on the machine
specifications plate located on the side panel.
b) It is compulsory to connect the machine to the power supply using a
dedicated omnipolar switch, in conformity with statutory safety
regulations. This switch must be automatic and with fuses that have a
minimum opening of 3mm between the contacts. The switch is not
furnished with the machine, it must be mounted on the wall in an easily
accessible position at a height between 0.6 and 1.70m.
c) Make sure that the electricity is not on before connecting the
power supply to the machine.
d1) Remove the front protection panel and the control panel by
removing the fixing screws.
d2) Unscrew the panel from the electrical panel and open it .
d3) Remove the PVC protection from the half-coils, insert the cable
through the fairlead and connect it to the half-coils labelled L1, and L3,
and hence attach the earth wire to the yellow-green terminal (N to blue
terminal).
must be carried
instructions and by
Page. 5
out according to
professionally trained
the