ASROCK FM2A75 Pro4-M Bedienungsanleitung Seite 28

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2, No. 30)
1. High Definition Audio supports Jack Sensing, but the panel
2. If you use an AC'97 audio panel, please install it to the front
System Panel Header
(9-pin PANEL1)
(see p.2, No. 21)
Connect the power switch, reset switch and system status indica-
tor on the chassis to this header according to the pin assignments
below. Note the positive and negative pins before connecting the
cables.
28
wire on the chassis must support HDA to function correctly.
Please follow the instructions in our manual and chassis
manual to install your system.
panel audio header by the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to
OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You
don't need to connect them for AC'97 audio panel.
E. To activate the front mic.
®
For Windows 7 / 7 64-bit / Vista
Go to the "FrontMic" Tab in the Realtek Control panel.
Adjust "Recording Volume".
ASRock FM2A75 Pro4-M Motherboard
This is an interface for the
front panel audio cable that
allows convenient connec-
tion and control of audio
devices.
TM TM
/ Vista 64-bit OS:
This header accommodates
several system front panel
functions.