208558B.fm Page 27 Thursday, April 26, 2001 11:03 AM
6.
Turn on power to the
When you supply power to the
supply modules and fans.
•
Be sure that the
•
Be sure that the power supply modules, DC connector cables, and power cable are
properly installed.
•
If the unit is located on a flat surface, be sure that you install four rubber feet
(included) to the bottom of the chassis.
Encender la
BayStack 10 PSU
Cuando se suministra energía a la
módulos de alimentación y a los ventiladores.
•
Asegurarse de que la
en una superficie plana.
•
Asegurarse de que los módulos de alimentación, los cables de conectores CC y el
cable de alimentación están instalados correctamente.
•
Si la unidad se ubica en una superficie plana, no olvidarse de instalar cuatro patas
de goma (incluidas) en la parte inferior del chasis.
.
BayStack 10 PSU
BayStack 10 PSU
is securely installed in a rack or on a flat surface.
BayStack 10 PSU
.
BayStack 10 PSU
está instalada firmemente en un bastidor o
BayStack 10 PSU
, you provide power to the power
, se suministra energía a los
27