Telcoma PASSO CARD Gebrauchs- Und Programmierungsanleitung Seite 37

- pass the MASTER CARD over the reader twice
- a series of double flashes of the LED on the front, and beeps, will start
- pass the new USER CARD to be memorised over the reader; a flash and
a longer beep confirm that the code has been acquired*
- proceed to memorise more cards, or wait for the LED to stop flashing.
(*) A series of 8 beeps and flashes of the LED indicates that the code is
already in the memory.
Procedure for deleting a USER CARD
- pass the MASTER CARD over the reader 4 times
- a series of 4 flashes of the LED on the front, and beeps, will start
- pass the USER CARD to be deleted over the reader; a flash and a longer
beep confirm that the code has been deleted
- proceed to delete more cards, or wait for the LED to stop flashing.
CLEARING THE RECEIVER MEMORY
WARNING! This procedure deletes all the codes in the receiver
memory.
Any PASSO digital keypads connected to this receiver will be
restored to their default condition, with MASTER code 1-2-3-4-5-6-7-
8.
Procedure: hold down button P1 on the receiver for about 10 seconds
until the red LED L1 lights up (det. 2 and 3 in fig. 3).
This operation does not delete the MASTER CARDS.
GB
36