Care And Cleaning - ROWENTA Intens Bedienungsanleitung

ROWENL17-A-725290:ROWEN200
3 • Storing and transporting
the appliance
After use, stop your appliance by pressing on
the on/off pedal and unplug it
Replace the cable by pressing the automatic
cord winder pedal

CARE AND CLEANING

CAUTION
your appliance before maintenance or
cleaning. Check and clean your vacuum
cleaner and the various filters regularly.
IMPORTANT
cleaner without the filtration system.
1 • Emptying the dust collector
Every time you use your vacuum cleaner,
empty the dust compartment as follows:
• Lower the handle to release the dust
compartment and remove i
• Press the release button of the dust
compartment
(fig.15)
.
• Clean the edges of the dust compartment
using a cloth
the appliance
• Once the dust compartment is back in
place, raise the handle to lock it
IMPORTANT
level shown on the dust compartment.
2 • Wash the black foam filter
IMPORTANT
suction power is unsatisfactory, wash the
black foam filter (2 filters provided).
Remove the separator cover
remove the Air Force System separator
(fig.20)
from its housing.
Separate the filter grill from the HEPA filter
(fig.21)
by turning it
(fig.22)
foam filter
black foam filter, you can use the spare black
(fig.22)
foam filter
29/05/08 18:09
(fig.10)
(fig.11)
.
Always turn off and unplug
Do not operate the vacuum
(fig.13)
.
(fig.14)
and empty it
(fig.16)
and fit it back onto
(fig.17)
.
(fig.18)
Do not fill above the max.
Each month or when
(fig.19)
. Remove the black
. When cleaning the 1st
.
Page 16
Your vacuum cleaner is easy to carry thanks
to its carrying handle and
shoulder strap
appliance with the accessories stored in the
.
park position (16).
When you store your vacuum cleaner
upright, place the tube in the space provided
on the rear of the appliance.
Wash and squeeze out the black foam filter
(fig.23)
.
Leave this black foam filter to dry for at least
12 H before fitting it again
IMPORTANT
to dry completely before fitting it into the
appliance again. Ensure that this black foam
filter is completely dry before fitting it to the
appliance.
3 • Cleaning the HEPA filter
(ref. ZR 0008)
IMPORTANT
fails to clean properly after cleaning the black
foam filter, then clean the filter HEPA.
IMPORTANT
ZR 0008 is available from your dealer or
Approved Service Centres.
.
Remove the cover from the separator
(fig.19)
and remove the Air Force System
(fig.20)
separator
Separate the filter grill from the HEPA filter
by rotating it
(fig.25)
foam filter
Turn over and clean the HEPA filter by
(fig.26)
tapping it
(fig.28)
cleaning
the dust compartment
lower the handle to release the dust
and
compartment, remove it
(fig.27)
out the tool
HEPA filter in order to make the dust fall out.
IMPORTANT: Do not insert the tool between
the folds of the HEPA filter to avoid
damaging it.
After use, store the tool in its position
(fig.29)
and fit the dust compartment again
(fig.17)
.
16
(fig.12)
. Do not transport the
(fig.23)
.
Allow this black foam filter
If your vacuum cleaner still
The HEPA filter ref.
.
(fig.21)
. Remove the black
.
. For more effective
, use the tool stored under
(fig.27)
. To do so,
(fig.13)
and take
. Shake the folds of the
GB